[an error occurred while processing the directive]
When you're working on your BCMSN exam on your way to CCNP certification, you'll read at length about how Cisco routers and multilayer switches can work to provide router redundancy - but there's another helpful service, Server Load Balancing, that does the same for servers. While HSRP, VRRP, and CLBP all represent multiple physical routers to hosts as a single virtual router, SLB represents multiple physical servers to hosts as a single virtual server.
In the following example, three physical servers have been placed into the SRB group ServFarm. They're represented to the hosts as the virtual server 188.8.131.52.
The hosts will seek to communicate with the server at 184.108.40.206, not knowing that they're actually communicating with the routers in ServFarm. This allows quick cutover if one of the physical servers goes down, and also serves to hide the actual IP addresses of the servers in ServFarm.
The basic operations of SLB involves creating the server farm, followed by creating the virtual server. We'll first add 220.127.116.11 to the server farm:
MLS(config)# ip slb serverfarm ServFarm
MLS(config-slb-sfarm)# real 18.104.22.168
The first command creates the server farm, with the real command specifying the IP address of the real server. The inservice command is required by SLB to consider the server as ready to handle the server farm's workload. The real and inservice commands should be repeated for each server in the server farm.
To create the virtual server:
MLS(config)# ip slb vserver VIRTUAL_SERVER
MLS(config-slb-vserver)# serverfarm ServFarm
MLS(config-slb-vserver)# virtual 22.214.171.124
From the top down, the vserver was named VIRTUAL_SERVER, which represents the server farm ServFarm. The virtual server is assigned the IP address 126.96.36.199, and connections are allowed once the inservice command is applied.
You may also want to control which of your network hosts can connect to the virtual server. If hosts or subnets are named with the client command, those will be the only clients that can connect to the virtual server. Note that this command uses wildcard masks. The following configuration would allow only the hosts on the subnet 188.8.131.52 /24 to connect to the virtual server.
MLS(config-slb-vserver)# client 184.108.40.206 0.0.0.255
SLB is the server end's answer to HSRP, VRRP, and GLBP - but you still need to know it to become a CCNP! Knowing redundancy strategies and protocols is vital in today's networks, so make sure you're comfortable with SLB before taking on the exam.
About the Author
Chris Bryant, CCIE #12933, is the owner of The Bryant Advantage (http://www.thebryantadvantage.com), home of free CCNP and CCNA tutorials! For my FREE "How To Pass The CCNA" or "CCNP" ebook, visit the website and download your copies. Pass your CCNP exam with The Bryant Advantage!